300-101 dumps does not need too much hard work but it has been designed for smart study.You can get handsome grades in your final by using this study material. It is just one click away from Realexamcollection.Information in this material has been presented in a way that you get all the required knowledge of the field from this one source.All the requirements of the exam have been considered to produce the best possible results.300-101 dumps material comes with money back guarantee.https://www.realexamcollection.com/cisco/300-101-dumps.html
Category
Education
2020 Download Updated Cisco 300-101 Dumps
Cis co
Exam 300-101
Implementing Cisco IP Routing
Version: Demo
[ Total Questions: 10 ]
https://www.realexamcollection.com/cisco/300-101-dumps.html
Topic break down
Topic No. of Questions
Topic 4: VPN Technologies 3
Topic 5: Infrastructure Security 1
Topic 6: Infrastructure Services 2
Topic 7: Mix Questions 4
2
Topic 4, VPN Technologies
Question No : 1 - (Topic 4)
A company has just opened two remote branch offices that need to be connected to the
corporate network. Which interface configuration output can be applied to the corporate
router to allow communication to the remote sites?
A. interface Tunnel0
bandwidth 1536
ip address 209.165.200.230 255.255.255.224
tunnel source Serial0/0
tunnel mode gre multipoint
B. interface fa0/0
bandwidth 1536
ip address 209.165.200.230 255.255.255.224
tunnel mode gre multipoint
C. interface Tunnel0
bandwidth 1536
ip address 209.165.200.231 255.255.255.224
tunnel source 209.165.201.1
tunnel-mode dynamic
D. interface fa 0/0
bandwidth 1536
ip address 209.165.200.231 255.255.255.224
tunnel source 192.168.161.2
tunnel destination 209.165.201.1
tunnel-mode dynamic
Answer: A
Question No : 2 - (Topic 4)
Which common issue causes intermittent DMVPN tunnel flaps?
A. a routing neighbor reachability issue
B. a suboptimal routing table
C. interface bandwidth congestion
D. that the GRE tunnel to hub router is not encrypted
Answer: A
3
Question No : 3 - (Topic 4)
Which encapsulation supports an interface that is configured for an EVN trunk?
A. 802.1Q
B. ISL
C. PPP
D. Frame Relay
E. MPLS
F. HDLC
Answer: A
Topic 5, Infrastructure Security
Question No : 4 - (Topic 5)
Which address is used by the Unicast Reverse Path Forwarding protocol to validate a
packet against the routing table?
A. source address
B. destination address
C. router interface
D. default gateway
Answer: A
Topic 6, Infrastructure Services
Question No : 5 - (Topic 6)
When a packet is denied by an IPv6 traffic filter, which additional action does the device
perform?
A. it scans the rest of the ACL for a permit entry matching the destination.
B. It generates a TCP Fin bit and sends it to the source.
4
C. A creates a null route for the destination and adds it to the route table.
D. It generates an ICMP unreachable message for the frame.
Answer: D
Question No : 6 - (Topic 6)
What is the purpose of configuring the router as a PPPoE client?
A. to provide VPN access over L2TP
B. to enable PPP session from the router to the termination device at the headend for
metroEthernet connectivity
C. for DSL connectivity and removing the need for the end-user PC to run the PPPoE client
software
D. for connecting the router to a cable modem, which bridges the Ethernet frames from the
router to the cable modem termination system
Answer: C
Explanation:
DSL Technology used PPPoE protocol (service provide end) and user end required to be
used same Protcol running as client to communicate with it
Topic 7, Mix Questions
Question No : 7 - (Topic 7)
Which two BGP neighbor states are valid? (Choose Two)
A. established
B. active
C. stuck in active
D. 2-WAY
5
E. unknown
F. DROTHER
Answer: A,B
Question No : 8 - (Topic 7)
A network administrator is troubleshooting a DMVPN setup between the hub and the
spoke. Which action should the administrator take before troubleshooting the IPsec
configuration?
A. Verify the GRE tunnels.
B. Verify ISAKMP.
C. Verify NHRP.
D. Verify crypto maps.
Answer: A
Question No : 9 - (Topic 7)
The OSPF database of a router shows LSA types 1, 2, 3, and 7 only. Which type of area is
this router connected to?
A. stub area
B. totally stubby area
C. backbone area
D. not-so-stubby area
Answer: D
Question No : 10 - (Topic 7)
What’s uRPF checking first when the packet enters the interface ? or when unicast reverse
patch forwarding is configured on interinterface.
A. it check the ingress access list
B. it check the egress access list
6
C. Route available in FIB ot it verifies a reverse patch via the fib to the source
D. it verify that the source has a
Answer: C
https://www.realexamcollection.com/cisco/300-101-dumps.html
7
Comments