Hire 20T Bubble crane in melbourne
                     MODEL: GR-200EX ROUGH TERRAIN CRANE
SPECIFICATIONS
MAXIMUM CAPACITY  20,000 kg at 2.5 m TADANO Automatic Following information is displayed:
PERFORMANCE Moment Limiter • Control lever lockout function with audible and 
   Max. traveling speed 54 km/h   (TADANO AML-E) visual pre-warning  • Number of parts of line
   Gradeability (tan    ) 66% (at stall), 57%*  • Boom position indicator  
* Machine should be operated within limit of engine  • Outrigger state indicator  • Slewing angle  
  crackcase design. (30º: Cummins QSB6.7-4C) • Boom angle / boom length / jib offset angle / jib 
WEIGHT length / load radius / rated lifting capacities / actual 
  Gross vehicle mass 19,960 kg loads read out  • Potential lifting height  
       -front axle   9,980 kg • Ratio of actual load moment to rated load moment 
       -rear axle      9,980 kg indication  • Permissible load
MIN. TURNING RADIUS 10.4 m (2-wheel steering), 5.7 m (4-wheel steering) • Automatic Speed Reduction and Slow Stop function 
                  (at center of extreme outer tire) on boom elevation and slewing 
BOOM 6-section full power partially synchronized • Working condition register switch
telescoping boom. • Load radius / boom angle / tip height / slewing 
  Fully retracted length 6.5 m range preset function  GR-200EX
  Fully extended length 27.5 m • External warning lamp
  Extension speed    21.0 m in 71 s • Tare function  • Main hydraulic oil pressure
  Angle -9º–82.5º • Fuel consumption monitor
  Elevation speed  -9º to 82.5º in 30 s • Drum rotation indicator (audible and visible type) 20 METRIC TON CAPACITY
JIB        2-staged under slung boom extension; main and auxiliary winch  • On-rubber indicator
          Single sheave at jib head. OUTRIGGERS 4 hydraulic, beam and jack outriggers. Vertical jack 
   O   f f s et 5º–60º(by offset cylinder) cylinders equipped with integral holding valve. Each 
Length      4.5 m and 6.9 m outrigger beam and jack is controlled independently 
M AIN WINCH  Variable speed type with grooved drum driven by from cab.
      hydraulic axial piston motor.    Extension width Max. ... 5,200 mm, Mid. ... 4,800 mm, 4,400 mm, 3,200 mm 
   S  i n  g  l e    l i n  e   p  u  ll     28.4 kN {2,900 kgf} Min. ... 1,790 mm, Float size (Diameter)... 400 mm Australian
Single line speed 120 m/min. (at 5th layer) CARRIER Rear engine, right-hand drive, driving axle 2-way 
Wire rope   14.0 mm x 155 m (Diameter x length)     selected type by manual switch. model
AUXILIARY WINCH   Variable speed type with grooved drum driven by 4 x 2 front drive, 4 x 4 front and rear drive.
          hydraulic axial piston motor. ENGINE Model... Cummins QSB6.7-4C
   S  i n  g  le line pull   31.4 kN {3,200 kgf}   EU)StageIV
   S  i n  g  le line speed 110 m/min. (at 3rd layer) Type... 4-cycle, turbo charged and after cooled,  
Wire rope  14.0 mm x 85 m (Diameter x length)      direct injection diesel.
SLEWING Piston displacement... 6.69 liters
 Slewing speed  2.6 min-1 {rpm} Bore x stroke... 107 mm x 124 mm
   T  a  il  s  lewing radius 2,390 mm Max. output... 175 kW at 2,300 min-1 {rpm}
HYDRAULIC SYSTEM Pumps... 2 variable piston pumps for crane functions. Max. torque... 888 N•m at 1,500 min-1 {rpm}
Tandem gear pump for steering, slewing TRANSMISSION Electronically controlled full automatic transmission.
and optional equipment. STEERING Hydraulic power steering controlled by steering wheel.
Control valves... 4 steering modes available: 2 wheel front, 2 wheel 
Electrically controlled multiple hydraulic rear, 4 wheel coordinated and 4 wheel crab.
valves with integral pressure relief valves. SUSPENSION Front: Semi-elliptic leaf springs with hydraulic lockout device.
Reservoir... 285 liters capacity. External sight level Rear : Semi-elliptic leaf springs with hydraulic lockout device.
gauge. TIRES  445/80R25 (OR)
Oil cooler... Air cooled fan type. FUEL TANK CAPACITY 250 liters
WORKING RANGE DIMENSIONS** (mm)
2 4
60
5 5° ° °
5°
35
6.9-m
82.5°  jib 30
4.5
70° -m jib
60°27.5- 0m 0 b 25 .: 27
,5
oom ,500–
MAX
23.3- 50° MIN
.: 6
m boo 45°m Ø40
1 40° 20 09.1-m boo 35°
14.9-m 30° boo 15
10.7-m b 20°
6. 105-m
 
10°
5 1,540
3,245 3,200 (WHEEL BASE) 1,865
6,605 (CARRIER LENGTH)
0° 8,310 (OVERALL LENGTH)
0
0 5 10 15 20 25
**In this external views, a few equipment are included.
LOAD RADIUS (m)
Note: Some specications are subject to change.
TADANO LTD.  (International Sales Division)
4-12, Kamezawa 2-chome, Sumida-ku Tokyo 130-0014, Japan
Phone: +81-3-3621-7750  Fax: +81-3-3621-7785
http://www.tadano.com/   E-mail: [email protected]
GR-200EX(AU)-3-E-18-9-01-86-562-A
Printed in Japan
LIFTING HEIGHT (m)
3,200 2,450
(OVERALL HEIGHT) (OVERALL WIDTH)
10.9°
18.3°
R2,390
17.8° MAX: 5,200
MIN: 1,790
m
m
oo
m
oo
m
b
The GR-21030EX is designed to comply Crane Capacity: 20,000 kg at 2.5 m
with Australian road regulations 6-Section Long Boom: 6.5 m—27.5 m
and is fully manufactured in Japan. 2-Staged Jib: 4.5 m / 6.9 m
Maximum Lifting Height: 
28.2 m (Boom)
35.0 m (Jib)
Maximum Load Radius: 
24.0 m (Boom)
27.8 m (Jib)
Overall Length: approx. 8,310 mm
Overall Width: approx. 2,450 mm
Overall Height: approx. 3,200 mm
Tire: 445/80R25
Min. Turning Radius: 
10.4 m (2-wheel steering)
5.7m (4-wheel steering)
ROUGH TERRAIN CRANE Benefits of the GR-200EX
GR-200EX ∙  Designed to comply    with Australian road regulations
∙  Fully manufactured in Japan
∙  Compact and quick set up
∙  Jib offset angle is adjustable 
   with newly equipped jib offset cylinder.
∙  Increased operator visibility 
   & Tadano View Camera System
1 GR-200EX GR-200EX 2
5˚ Utilizing the 2-stage hydraulic offset jib increases preparation work efficiency
First in its class to adopt a 2-stage hydraulic offset jib with the first radio control 
for a rough terrain crane.
 This increases work efficiency while supporting safety features.
60˚
4.5 m / 6.9 m Radio control 
Hydraulic offset jib New
Hydraulic offset jib can be adjusted between 5° to 60° set-up
with the jib offset cylinder. 
First rough terrain crane with radio control. First timefor the rough terrain crane
6.5 m—27.5 m With the hydraulic under slung jib pared *Optional feature
with a set up remote control, one man configuration, 
especially in narrow spaces, are safer, faster and effortless.
Outrigger control
Outrigger operation mode supports 
outrigger extension and retraction 
as well as jacking.
Hook stowage
Boom storage operation allows stowing of the hook with visual confirmation 
outside of the crane.
Jib installation and storage
Under-Slung Jib Jib set-up mode puts jib installation and storage 
-9°—82.5° A two-stage, under slung jib right at your fingertips with the radio control set-up.
makes installation in narrow 
space possible. Number of times the Conventional equipment
carrier must climbed 
in and out of during 4 times 1 time
jib installation via (4 times if radio control 
radio control set-up is not used)
3 GR-200EX GR-200EX 4
Optimum Design Large multi-function display
Crane cabin and equipment designed for operator comfort. The 10.4 inch color touch panel consolidates operation information and settings for 
increased work efficiency and comfort. The touch panel is pressure sensitive to handle 
gloved operation.
Number of parts of line Number of parts of line 
Moment load ratio for main winch wire rope for auxiliary winch wire rope
Winch drum monitoring camera
Drum indicator
Hook load
Rated lifting 
capacity
Outrigger status
 indicator
Operation status
Working area
Slewing position
Example)
New Working area 
DEF/AdBlue level gauge button Operation status display
when outriggers 
Hydraulic oil temperature are asymmetrically 
indication Fuel consumption monitor Operation indicator extended
working area setting
Operation feel Comfort
Adopted an electric operating system for operations Overhauled operation comfort 
with an unprecedented response feel.  This enables operation that and suspension sheet. A helmet 
responds to the feeling of the operator. can be worn without removing 
the headrest.
Speed can be set 
individually for rotation, 
boom hoist and jib tilt 
operations at 5 levels.
Operator can work at 
own custom speed for 
more precise lifting.
Operation speed settings screen
Adjustable rotation sensitivity
Customiseable sensitivity control 
for increased stability.
Visibility 
Normal operations
With speed adjustment The shape and height of the 
With adjusted sensitivity instrument panel as well as 
the angle of the windshield 
have all been designed for 
optimum forward visibility.
New cabin
Amount of lever operations
5 GR-200EX GR-200EX 6
Actuator speed
HELLO-NET New
HELLO-NET is a tool that connects the crane operations with owners, their service staff and the manufacturer through satellite. 
This high quality telematic tool collects data of the crane including working history, maintenance data and machine location. 
HELLO-NET can be accessed by the manufacturer to assist with downtime and to help improve Tadano support services.
Satellite 
communications
GPS
Owner Service TADANO
Ground 
Work site station
Reduce fuel consumption
Fuel monitoring
TADANO View System Checking fuel consumption enables operator to prevent wasteful fuel consumption from unnecessary acceleration and idling.
The average fuel consumption is shown 
Supports safety functions from a birds-eye view image of crane when your crane is operated.  Fuel consumption during standby is 
automatically displayed when each control 
lever and pedal is in neutral position.
Supports safety confirmation through an above-the-vehicle 
image shown on the large multi-function display.
*Camera range is limited. Do not rely only on the image. Conrm safety around the Fuel consumption Average fuel 
vehicle directly before driving. during standby consumption
Preset menu display Fuel consumption history display Fuel consumption history display 
(during crane operation) (during crane operation) (during traveling)
Positive Control System Eco Mode System
Effectively controls the quantity of hydraulic pump Controls the maximum engine speed at the time of 
discharge during crane operation in response to crane operation and enables fuel consumption and 
the amount of movement applied, and reduces CO2 CO2 emission to decrease by Max.16% with Eco
Cameras are equipped on all four consumption by up to Max. approx. 21% . mode 1, and Max.34% with Eco mode 2, and noise 
sides of the vehicle for images level is reduced.
from four directions.
Front image during normal driving Aft image during reverse driving
Human alert system (person detection warning) High performance engineFirst worldwide!
Cummins QSB6.7SCR
This covers the left side of the vehicle, which is difficult to check from the driver's seat. When detected, 
Emission gas cleaning system is
a buzzer alerts the driver of people walking, riding bicycles, etc.
SCR(Selective Catalytic Reduction) 
*Detection may not be possible or may be slow depending on light in the area as well as speed of both the vehicle and people.
+ DOC(Diesel Oxidation Catalyst)
Adblue® tank
Detection camera
Front steps Wheel chocks Aluminum plates Plastic plates
7 GR-200EX GR-200EX 8