How To Find Your Partner’s Wedding Ring Finger Size Without Asking_KernsFineJewelry
                     Kerns Fine Jewelry
www.kernjewelers.com
How To Find Your Partner’s Wedding Ring 
Finger Size Without Asking
Introduction
• Asking your partner what ring size they wear is a terrific way to 
ruin the entire surprise proposal. 
• There are several tips with which it is possible to measure the size 
of your partner's finger without their knowledge. 
• Be it diamond wedding bands, gold wedding rings or platinum 
wedding bands, it is of no value if it does not fit properly. 
• There are a few frequent mistakes to watch out for when trying to 
figure out your partner's ring size. 

• Rings that are one-half size larger may be easier to put on and 
take off for your significant other if they have particularly huge 
knuckles. 
• When sizing an engagement ring, go a half-size larger than you 
think you need, because you can always have the bridal wedding 
rings resized by a jeweler.
Different ways to find out the ring size
• The different ways in which you can know about the ring size of 
your partner in a secretive manner. Here are a few tips to follow. 

Ask it out from a friend or relative
• If you want to know your partner's ring size, this is the quickest 
and easiest method, however, cannot be relied upon. 
• Inquire about your partner's friends and family members who 
could be able to answer your questions. Parents and shopping 
partners alike might also remember the ring size. 
• However, relying on someone else's opinion can result in incorrect 
information. 
• Women typically wear rings in the range of sizes 6–10, with the 
latter being more common among men. 

Measure it off while they are asleep 
• In order to get an accurate ring size for the wedding bands, it is 
best to wait until your companion is asleep. 
• The key is not to startle them, so get all of your supplies ready in 
advance. In order to construct your own measuring tool for ring 
sizes, you'll need some string, a pen, a millimeter ruler, and some 
scissors.
• Rings have tolerance.04 millimeters per half-size. Discard the string 
when it has been cut to a 5 or 6-inch length. Start at the zero mark 
and run your string along the ruler.

• Start with 14mm size-3 and mark every.04mm or half-size till 
20.6mm. As a general rule, the diameter of a size-6 ring for women 
is 16.5mm, while for men, it is 20.2.
• It is best to use distinct colored markers for each ring size above 
size 5 because you are performing a secret mission with an 
emphasis on accuracy. 
• The difference in color will help you get an accurate measurement 
in a dark room.

• The pinky finger on the left hand is where the engagement ring will 
be placed. Because engagement rings are worn every day, they 
should be snug but not uncomfortable. 
• In order to avoid arousing your partner, this is a convenient 
method for taking your measurements.
• You can also refer to any of her old rings as a size reference. Either 
ask it casually from her or if required, steal it in a way she would 
never know. 
Contact Information Kerns Fine Jewelry
Store Location
Address: 214 Lorton Avenue, Burlingame, CA 
94010
Phone: (650) 348-7557
E-Mail: [email protected]
Website: https://www.kernjewelers.com
Store Hours
Tuesday - Saturday 10:00 am - 5:00 pm
(4:00 pm Last Appointment)
Sunday & Monday CLOSED