10 Easy Steps for Replacing Car Tyre at Home1
                     10 Easy Steps for Replacing Car Tyre at Home
Position Vehicle & Prep Area
Park on level ground and prep a clean area to work. Put on 
gloves, eye protection.
Loosen Lug Nuts
While the wheel is 
still on the 
ground, use your 
tyre iron or impact 
wrench to slightly 
loosen the lug 
nuts securing it.
Jack up Vehicle 
Position jack 
underneath vehicle at 
approved jacking 
points and raise until 
wheel is just off the 
ground.
Remove Lug Nuts & Wheel
With the vehicle weight no 
longer on it, finish unscrewing 
lug nuts with your fingers/tool 
and take off the wheel.
Remove Old Tyre
Deflate completely. Then 
push the beads in from the 
sides to unseat the tyre 
edges. Lift off rim.
Install New Tyre
Fit one tyre bead edge into the 
outer rim lip. Then use a 
lubricant and tyre irons to 
ease the 
reliable tyre replacement s
ervices
 without twisting or damaging 
the rubber. 
Reattach & Secure Wheel
Place wheel flush back on 
vehicle hub and perform up 
an initial hand tighten of 
lug nuts to temporarily hold 
it in place.
Recheck 
AfteTr oraq ueshort drive, 
recheck torque settings 
and finally consider 
getting a 
wheel alignment done 
to maximize lifespan.
Lower Vehicle 
Raising the jack back 
down until the full 
vehicle weight holds 
the newly fitted wheel 
in place.
Torque Lug 
UsNinugts a torque 
wrench, tighten bolts 
to spec in opposite 
star pattern. Double 
check each.
Always put safety first with axle 
stands supporting vehicles and by 
matching new tyres to existing wheel 
sizes. Seek 
24hr Mobile Tyre repair London pr
ofessional
 assistance if unsure during any points 
of 
mobile tyre replacement in London.
 020 8050 9024
 [email protected]
www.mobiletyrerepairlondon.co.uk