DIY Tyre Fitting Guide Brought to You
                     DIY Tyre Fitting 
Guide Brought to You 
When it's time to replace worn or damaged 
tyres, avoid garage wait times by having our 
Mobile Tyre Fitting London experts attend 
your home or workplace anywhere in 
London for convenient fitting. But for 
competent DIYers, here is a safe tyre fitting 
process:
Position Vehicle
Park on a solid level surface with ample 
working room all around the wheel 
arches. Engage parking brake and chock 
opposites sides of wheels remaining on 
the ground.
Loosen Lug Nuts 
While wheels are still supporting 
vehicle weight, crack-loosen each 
lug nut securing the wheel but don't 
remove yet.
Raise Vehicle
Position hydraulic trolley jack 
beneath approved vehicle jacking 
points. Lift until tyre just lifts off 
the ground. Immediately support on 
an axle stand.
Remove Wheel
Finish unscrewing all loosened lug 
nuts by hand before carefully 
extracting the wheel from the hub 
mounts.
Change Tyre
Deflate old tyre completely before 
breaking the bead seal and prying 
tyre edges off the rim. Refit 
replacement tyre by hand ensuring 
correctly centred.
Refit Wheel
Offer the wheel straight back onto 
the hub studs without damaging 
mating surfaces. Perform initial 
hand tighten of lug nuts to hold in 
place.
Lower Vehicle
Raise jack to allow full vehicle 
weight to bear down on newly fitted 
tyre and wheel assembly.
Final Torque
Use calibrated torque wrench to 
fully tighten lug nuts to spec in 
opposite star pattern.
Recheck Torque
After a short drive, reconfirm 
correct torque settings are still 
adhered to on all lug nuts.
For mobile assistance with tyre
 fitting at your London home or 
Tyre Fitting at London
workplace, contact 24hr Mobile 
Tyre Fitting London.
24hr Mobile Tyre Fitting London
02080509024
020 8050 9024
[email protected]
[email protected]