N10-007 Online Test Engine - Free Demo Question From Dumps4Download
                     CompTIA N10-007 Dumps PDF
                     C  o mpTIA Network+ N10-007
For More Info:
https://www.dumps4download.com/n10-007-dumps.html
 
Question: 1 
   
A UTM is deployed on the external edge of the main corporate office. The office connects to the 
WAN port of the edge router. The edge router at the main office connects to the remote offices using 
GRE IPSec tunnels. A network administrator notices that a worm that was not detected by the UTM 
has spread from the remote sites into the corporate network. The UTM currently has traffic rules 
applied that should block the port used by the worm. Which of the following steps would MOST 
likely correct this issue? 
 
A. Move the UTM onto the LAN side of the network 
B. Enable TLS inspection on the UTM 
C. Enable stateful inspection on the UTM 
D. Configure the UTM to deny encrypted files from being transferred 
 
Answer: C     
 
Question: 2 
   
A technician has racked a new access switch and has run multimode fiber to a new location. After 
installing an extended-range 10Gb SFP in the core switch, the technician installed a 10Gb SFP in the 
access switch and connected the port to the new extension with a fiber jumper. However, the link 
does not display, and the technician cannot see light emitting from the core switch. Which of the 
following solutions is MOST likely to resolve the problem? 
 
A. Swap the fiber pairs in one of the SFPs 
B. Replace the jumpers with single-mode fiber 
C. Set the correct MTU on the new interface 
D. Install an optic that matches the fiber type 
 
Answer: B     
 
Question: 3 
   
A network technician has implemented ACLs to limit access to cloud-based file storage. Which of the 
following security mechanisms has the technician enforced? 
 
A. DLP 
B. IDS 
C. WAF 
D. WPA 
E. TPM 
 
 
Answer: C     
 
Question: 4 
   
HOT SPOT 
You have been tasked with testing a CAT5e cable. A summary of the test results can be found on the 
screen. 
Step 1: Select the tool that was used to create the cable test results. 
Step 2: Interpret the test results and select the option that explains the results. After you are done 
with your analysis, click the 'Submit Cable Test Analysis' button. 
 
 
 
 
Answer:  
 
 
 
 
Explanation: 
A Cable Certifier provides “Pass” or “Fail” information in accordance with industry standards but can 
also show detailed information when a “Fail” occurs. This includes shorts, the wire pairs involved and 
the distance to the short. When a short is identified, at the full length of the cable it means the cable 
has not been crimped correctly. 
 
Question: 5 
 
A firewall administrator is implementing a rule that directs HTTP traffic to an internal server listening 
on a non-standard socket. Which of the following types of rules is the administrator implementing? 
 
A. NAT 
B. PAT 
C. STP 
D. SNAT 
E. ARP 
 
Answer: B     
 
 
Question: 6 
   
A technician is installing a new wireless badging system on a hospital network. The requirements of 
the badging system are for it to have its own SSID and low power levels. The badging system has to 
cover 99.9% of the hospital. Which of the following is the BEST action to take to meet the system 
requirements? 
 
A. Install additional WAPs 
B. Install external antennas 
C. Move the WAPs closer to the more populated area 
D. Change the antenna types 
 
Answer: A     
 
Question: 7 
   
A technician attempts to replace a switch with a new one of similar model from the same vendor. 
When the technician moves the fiber and SFP plug, the switch does not completely boot up. 
Considering that the config files are the same, which of the following is the MOST likely cause of the 
failure? 
 
A. Damaged fiber 
B. Corrupted operating system 
C. VLAN mismatch 
D. Bad port 
 
Answer: B     
 
Question: 8 
   
A company has hundreds of nodes on a single subnet and has decided to implement VLANs. Which of 
the following BEST describes the benefit of this approach? 
 
A. It segments broadcast domains in the network infrastructure. 
B. It provides a faster port to all servers. 
C. It provides multiple collision domains on one switchport. 
D. It provides multiple broadcast domains within a single collision domain. 
 
Answer: A     
 
 
Question: 9 
   
A company has completed construction of a new datacenter, and the IT staff is now planning to 
relocate all server and network equipment from the old site to the new site. Which of the following 
should the IT staff reference to determine the location of the equipment being moved? 
 
A. Rack diagrams 
B. Network topology 
C. Standard operating procedures 
D. Wiring documentation 
 
Answer: A     
 
Question: 10 
   
Which of the following would allow a device to maintain the same IP address lease based on the 
physical address of the network card? 
 
A. MAC address reservation 
B. Static IP address 
C. IP address exclusion 
D. Custom DNS server entry 
 
Answer: A