jitter speed Test
                          JITTER SPEED TEST
What is jitters in speed test?
Jitter: Also called Packet Delay Variation (PDV), jitter frequency 
is a measure of the variability in ping over time. Jitter is not 
usually noticeable when reading text, but when streaming and 
gaming a high jitter can result in buffering and other 
interruptions.
What is a good jitter speed?
Acceptable jitter simply refers to the willingness to accept irregular 
fluctuations in transferring data. For best performance, the jitter 
must be kept below 20 milliseconds. If this exceeds 30 
milliseconds, then it will cause a noticeable impact on the quality of 
any real-time conversation that a user may have.

Why is my jitter so high?
Network congestion – Not enough bandwidth is a common problem. 
Networks become overcrowded with traffic congestion when too many 
active devices are consuming bandwidth. Poor Hardware Performance 
– Older networks with outdated equipment including routers, cables or 
switches could be the causes of jitter.
How do you test for jitter?
The jitter is found by finding the average of the time difference 
between each packet sequence. For Example: The difference 
between 58ms and 1ms: 57 ms. The difference between 1ms 
and 58ms: 57 ms.
Is jitter good or bad?
Jitter is an undesired distortion of a signal. ... In all cases, where 
there is jitter, the data stream as conveyed to the receiver will 
contain inaccurate information or have bit errors. If the jitter is very 
bad, it can cause system failure.
Why is jitter bad?
Jitter is measured in milliseconds (ms). A delay of around 30 ms or 
more can result in distortion and disruption to a call. For video 
streaming to work efficiently, jitter should be below 30 ms. If the 
receiving jitter is higher than this, it can start to slack, resulting in 
packet loss and problems with audio quality.
Is low or high jitter better?
Jitter is the irregular time delay in the sending of data packets over 
a network. Acceptable jitter means what we are willing to accept as 
the irregular fluctuations in data transfers. ... Jitter should be below 
30 ms. Packet loss shouldn't be more than 1%.
How do I fix jitter problem?
● Upgrade your Ethernet cable to fix Ethernet problems (Cat 6 is 
currently your best choice)
● Choose wired connections over Wi-Fi always, if possible.
● Use a powerful router that can handle the full bandwidth of your 
Internet connection.
● Opt for high-speed Internet connections such as fiber optics.
Contact Us
Address : K-Street, 1667k Street NW Washington DC 2006
Website : https://internetspeedtest.world/https://internetspeedtest.world/jitter-test
      THANK YOU