Batteries Tesitng
                     URS Products & Testing 
PVT.LIMITED
Batteries Testing
▪ Battery/cell is one of the most critical source of power in most of 
the electronics products use widely. These play a very important 
role in product designing and also on product life. These are very 
useful and in the same way very dangerous if not use as per 
technical requirements and instruction.
 +91-9971300904 , [email protected], www.urs-labs.com , F-3, Sector 6, Noida (INDIA)
 PURPOSE OF A 
BATTERY
▪ The primary purpose of an battery is to provide a source of 
electrical power for starting and for electrical demands that 
exceed generator output. The battery is a voltage stabilizer 
because it acts as a reservoir where large amounts of current 
(amperes) can be removed quickly during starting and replaced 
gradually by the generator during charging.
▪  The battery must be in good (serviceable) condition before the 
charging system and the cranking system can be tested

Battery  / Cell  Standards
▪ IS 16046-1
▪ IS 16046-2
▪ IEC 62133-1
▪ IEC 62133-2
▪ UN38.3
▪ IEC 60896
▪ IS 16047
▪ IS 16270
Main Tests
▪ Charging / Discharging Test ▪ Crushing Test
▪ Insulation Resistance Test ▪ External short circuit Test
▪ Continuous charging Test ▪ Free fall Test
▪ Vibration Test ▪ Mechanical Shock Test
▪ Moulded case stress at high ▪ Thermal abuse Test
ambient temperature Test ▪ Low-pressure Test
▪ Temperature Cycling Test ▪ Over-charging Test
▪ Incorrect installation Test ▪ Forced discharge Test
6
How Battery Works
▪ A fully charged lead-acid battery has a positive plate of lead 
dioxide (peroxide) and a negative plate of lead surrounded by a 
sulphuric acid solution (electrolyte). Difference in potential 
(voltage) between lead peroxide and lead in acid is 
approximately 2.1 volts. During Discharging The positive-plate 
lead dioxide ( PbO 2 ) combines with the SO 4 from the 
electrolyte and releases its O 2 into the electrolyte, forming H 2 
O . The negative plate also combines with the SO 4 from the 
electrolyte and becomes lead sulphate ( PbSO 4 ).
Why Test Battery 
System
There are two main reasons to test a battery:
1- To insure the supported equipment is adequately backed up.
2- To prevent unexpected failures.
Why Choose US
▪ URS Lab is NABL Accredited as per ISO 17025 for Electrical 
(Household, Luminaries, Batteries & Environmental, etc.), 
Electronics (IT, Audio Video, UPS & EMI/EMC, etc.) and 
Mechanical (Automotive & Toys) Testing.
 +91-9971300904 , [email protected], www.urs-labs.com , F-3, Sector 6, Noida (INDIA)
Reach Us
+91-9971300904 , +91 (120) 4516264, 65
[email protected]
www.urs-labs.com
F-3, Sector 6, Noida (INDIA)