Installing The New Toilet Seat Is Easy – Here Are A Few Quick Steps To The Toilet Seat
                     Installing The New Toilet Seat Is Easy – Here Are A Few Quick Steps To The Toilet Seat
Replacing a toilet seat is not a big project that you need to appoint a handyman to do. It 
is simple &straightforward, and you can do it with minimal DIY skills. It will be a 15 to 
30 minutes job, and anyone can do it with a bit of effort. Anyone who needs a quick 
bathroom upgrade will find it to be a simple, economical, and pleasant project.
• To install new toilet seats, you first need the basic materials for the job. Next, you have to 
decide the brand of the toilet seat you want to purchase & install. You can buy a Bellavista
 toilet seat from your nearby hardware store or an online store like Cheap Replacement Toilet 
Seats. They have a wide variety of new toilet seats for your toilet, and they offer you complete 
advice to help you identify your Bellavista toilet seat model. 
• The Bellavista 
toilet seats are 
designed based 
on high-density, 
water-repellent 
MDF, a type of 
board that is 
highly resistant 
to breakage and 
impact. It is 
suitable for your 
interiors where 
exposure to 
water and 
humidity is 
high. It will cost 
anywhere from 
£130 to £180 or 
even more 
based on your 
specific need.
• The soft close 
Bellavista toilet seat 
comes with nuts, bolts, 
and hinges to the 
toilet. You need some 
essential tools such as 
a plier, wrench, 
fastener, cleaning 
agents, safety gloves 
and new bolts that 
come with the seat. 
Few instructions to 
follow to replace a 
toilet seat:
•Wear the safety gloves clean the old toilet seat, rim, and bowl, and close the lid
•Check the backside of the toilet pan. Here you will find two bolts that connect the lid to the bowl.
•The screw is sealed in plastic caps. So you pop off the caps right away.
•Two long bolts are kept in place by nuts on the underside of the lid. To loosen the nuts from the bolts, use the 
wrench.
•Remove the nuts from the bolts & detach the bolts from the toilet. Separate the seat & lead. You will get the 
bare toilet rim with two tiny holes at the back.
•You will no longer require any parts from your old seat, so dispose of it carefully.
•Your new seat must have two hinges & bolts affixed to it, & a set of rubber grips & a set of plastic or metal 
nuts.
•Line up the rubber grips with the hinges, then get prepared to put the new Bellavista toilet seat on the bowl.
•Line up the bolts with the two holes at the backside of the rim. Thread the bolts through the holes, then close 
the new seat & lid onto the bowl.
•Ensure that the new toilet seat is correctly lined up against the rim.
•On the underside of the lid, find the bolts & thread the new nuts onto them.
•Use the wrench to tighten to the points where the new Bellavista toilet seat & its lid are held firmly in 
position.
• Address: Unit 3 Global Business Park, 4 HAMBURG ROAD, HULL, 
East Riding of Yorkshire HU7 0AE
• Phone: 7552414763
• Email: [email protected]
• Website: https://cheapreplacementtoiletseats.co.uk/