Guide On Installing Roof Shingles
                     How To Install Roof Shingles?
No matter how you maintain and repair your roof, the time comes when you need a new roof.
Knowing how to install roof shingles can help you better manage and preserve your roof. A
skilled do-it-yourselfer may complete the difficult  task of installing shingles with the correct
equipment,  safety  precautions,  and  adherence  to  the  manufacturer's  recommendations.
However, it is safe to consult the leading roofing contractors in Santa Clarita for the best
guidance. The experts know the job and provide desired solutions for better outcomes.
Here Are The Ways To Install Roof Shingles
Remove Old Shingles
Use a roof shovel to get rid of the shingles, nails, and underlayment. To remove the old roofing
material from the roof deck, slide the shovel underneath it. Flashing should be removed from
around windows, chimneys, skylights, siding, etc.
Clean Off Debris
Scrape off  materials that were left  after using the shovel.  Any remaining fasteners for the
underlayment  or  shingles  should  be  removed  with  a  claw hammer.  Sweep the  roof  deck
thoroughly to remove all dirt and debris.
Install Flashing
Each of these sections should have flashing that has been rolled out and secured with roofing
nails at the outer borders, leaving the middle unnailed. If you nail too close to the middle of this
flashing, your roof will  leak. Now place roofing cement between each row of shingles. Any
chimneys or skylight windows should have flashing added around them to protect them from
the elements.
Install Underlayment
Following  the  manufacturer's  directions,  install  the  underlayment  on  the  deck,  including
features  like  rakes,  sidewalls,  and  ridges.  Maintain  a  tight,  straight,  and  wrinkle-free
underlayment. Each additional row of underlayment may need to be overlapped, depending on
the pitch of your roof. Install drip edge flashing along the roof's rakes after the underlayment is
in place.
If you think roof replacement in Los Angeles is a DIY task, you might want to rethink that
notion. It is better to take an expert’s help.
Install Shingles
Lay  a  row  of  starter  shingles  along  the  lower  border  of  the  roofline  to  start  the  shingle
installation process. Utilize roofing nails to fasten them. Lay a set of starter shingles around the
roof's sides after laying the starter shingles along the border of the roof. As they descend,
ensure that the rows cover the starter shingles you placed at the bottom. Depending on the
slope of the roof and manufacturer guidelines, you might also need to use roofing cement to
hold the shingles.
Install  courses  of  shingles  on  the  roof's  ridge.  For  the  other  side  of  the  roof,  repeat  the
installation  procedure.  Follow  the  expert’s  suggestions  when  installing  a  ridge  vent  (if
necessary) and ridge cap shingles.
Conclusion
The  shingle  installation  process  seems a  daunting  task.  You  can  better  comprehend  the
intricacies  of  the  entire  process with  a better  understanding of  the  processes required  to
shingle a roof. So, hiring one of the best roofing companies in Moorpark is recommended. 
**************************************Source**************************************
https://complete-roofing-santa-clarita.mystrikingly.com/blog/how-to-install-roof-shingles