How Can A Hot Water Heater Be Cleaned?
                     How To Clean A Hot Water Heater?
Every  homeowner  desires  uninterrupted  daily  life  but  lacks  an  appliance
maintenance routine. The lifespan of your appliances is crucial for the smooth flow of
daily activities in the house. However,  lack of regular maintenance leads to daily
hassle. Consulting an HVAC company in Sacramento can help you save money in
the long run. Checking that your water heater is functioning ensures that your home
uses energy and water efficiently.  Over time things like lime, calcium, and other
minerals accumulate in the base of your water heater. As a result, your water heater
works harder to heat the water for your home and reduces lifespan. The best way to
get rid of that mineral build-up is to clean your water heater.
Here Is How You Clean A Water Heater.
Turn It Off
Switch the power off if your water heater is electric. Set your thermostat to "pilot" if
your water heater is a gas heater. This turns off your water heater's heating element,
allowing the water to cool.
Drain The Tank
Switch off the cold water valve to empty your tank of water. If you skip this step,
water will keep flowing into the tank and draining, which might significantly increase
your water bill. Place a bucket below the drain valve. Next, join the valve with the
end of a garden hose. Place the hose's other end next to a floor drain, a sink, or, if
it's long enough, outside. To release the contents of the tank, open the valve.
Refill The Tank
Refill the tank with cold water to lose the remaining sediment. This step is important
if you have hard water running in your area because hard water contains dissolved
minerals and creates low water pressure problems.
Brush It Off and Flush
You can also brush the interior lining of your tank to remove more sediment. You can
use refrigerator coils to clean the interior lining. Next, you remove the drain valve to
let the brush in. Gently scrape the hardened minerals at the bottom and the lower
sides. A refrigerator coil  is an effective tool for cleaning the interiors of the tank.
Flush the tank one last time to ensure proper cleaning.
After draining the tank, turn off the drain valve, switch on the cold water and let the
tank fill.  Turn on your water heater. Your water heater is ready to function again.
Sometimes, cleaning is not enough because of excessive wear and tear. You can
consult an expert for a new water heater installation in Sacramento.
Conclusion
Water heater flushing is important because sediment build-up will cause problems,
affecting your  daily  life.  Failure  of  components  like  clogged pipes or  the heating
element,  loss  of  heating  power,  and  potential  health  problems  for  those  who
consume the water can all be caused by letting sediments and calcium deposits build
up in the tank.
************************************Source************************************
https://blogghere.com/how-to-clean-a-hot-water-heater/