How to Fix Bosch Dishwasher Error Code E09
                     How to Fix Bosch 
Dishwasher Error 
Code E09?
HOMEMAKERCHIC.COM
 A Bosch Dishwasher Error Code E09 Is 
a Heating Element Problem
There is a good chance that the heating element has 
been burnt. Therefore, it might need to be replaced. On 
the other hand, it could be an electrical problem, causing 
the heating element to have issues. 
You need to think about the possible reasons why this 
might have happened.
The Water Is Leaking from the Heating 
Element
One of the first concerns that could be developing with 
your dishwasher is that water is leaking from the heating 
element. Over time, the seals and gaskets in the 
appliance are going to wear out. This could cause leaking 
to occur. 
As a result, water could begin to coat the heater and 
motor. This causes the body to lose its tightness. This 
could also cause the heating element malfunction, 
leading to problems.
There You Are Using Hard Water
Is a Clogged Filter Present
You may also notice that there is a clogged filter. If the 
filter is clogged, water is not going to be able to drain 
appropriately. This could cause the heater to overheat.
Fortunately, this is something that you may be able to 
fix. If you can spot the mesh filter, you may be able to 
unclog it, fixing the problem.
Voltage Issues
Finally, you may also want to take a look at wiring and 
voltage issues. If you do not have a voltage regulator 
connected to the dishwasher, and there is a problem with 
the power grid, this could cause the heating element to 
burn. This can also cause an E09 error code to appear.
You Are Using Hard Water
If you do not have high-quality water, this could also 
impact the operation of the dishwasher. If you are using 
hard water, there is a lot of scales that could take place. 
This can lead to a thick layer, forcing the heating element 
to work harder.
Eventually, the heating element is going to overheat and 
burn, leading to problems. You may need to take steps to 
reduce the appearance of scale
To address an error code E09, you 
should:
•Start by unplugging the dishwasher once again. You also need to unplug the dishwasher from the water 
supply, sewage system, and other utilities that could be present in the building.
•Next, you need to remove the plastic clips that are located at the edge of the dishwasher itself. They 
should not be that hard to unclip. Simply remove them to release the dishwasher.
•Next, you need to remove the screws in the front part of the equipment to release it. That way, you will 
be able to access the entirety of the dishwasher.
•If your Bosch dishwasher has thermal insulation, you will need to remove this as well. That way, it does 
not get damaged during the process.
•Once you have done all of this, you can open up the tub door. Pull out all of the racks. You should also 
remove the spray arm as well as the filter. If your filter has mesh in it, you need to remove this as well.
•There are probably several screws that are responsible for holding the circulation pump in place. You 
need to unscrew them and remove this as well.
•After you are done doing this, you need to unscrew the sump. Make sure you remove this to access the 
heating element.
•You need to remove everything that is responsible for holding the circulation unit in place. This includes 
wires, hoses, and nozzles. After this, you should be able to remove the heating element.
INFORMATION SOURCE
Homemakerchic.com