Replacement Hot Tub Spa Control System Complete
                     Replacement Hot Tub Spa 
Control System Complete
-By Hot Tub Parts FD
Replace your old spa control system 
Are you looking for a circuit board or topside 
controller for your hot tub but finding them pricey 
and difficult to find? 
Replace your old spa control system with a new 
one instead of throwing it away and taking it to 
the landfill.
For someone with ordinary mechanical abilities, 
installation is straightforward. The cost of 
replacing worn-out equipment components might 
be thousands of dollars less. 
Control system: Know about It 
The hot tub's brain is the spa pack or 
control system. This central nervous 
system controls spa operations and 
equipment, including the spa jet pumps, 
filtration time, and heating.
Electronic, digital control systems and 
mechanical air controls are the two main 
controls utilized in hot tubs.
Digital System - Solid-state computer-controlled 
systems are known as digital controllers. Onboard 
diagnostics and advanced filtering cycles are both 
supported by the circuit board. Using the control 
keypad on top of the spa, you may talk to your 
control pack. Error Codes will be shown if there are 
any problems.
Air System - A puff of air is used to activate or 
deactivate a function in non-digital air systems. In 
the 1970s and 1990s, the early tubs employed 
pneumatic switch controls. Even if they are still 
accessible, most air systems have been replaced 
with digital controls. Digital controls are a great 
option if your tub has an outdated air system.
Options for a Control System: 
Types of the heater- 
Knowing what kind of heater it currently has is 
crucial when it comes time to repair your spa's 
control system. High Flow and Low Flow heaters 
are the two most common kinds of heaters.
With your new spa control system, you will get a 
new heater. To ensure the safety of your new 
system, the piping and current pumps must be 
compatible with the new pack.
A crucial part of components- 
Digital or air controls have been picked, and the 
heater type has been chosen, so now you're ready 
to begin.
Determine how many pumps and other circuits 
your tub will require as the next step in the wiring 
process.
Follow each connection from the control system to 
its corresponding component to figure out what's in 
your tub. Make a note of the voltage on each data 
label after you've located it on the circuit board.
It's time for the Installation and Setup process-
Here is a broad summary of the procedures needed in 
installing a control system.
The panel for accessing the spa's equipment may be 
opened.
Ensure that all equipment is disconnected from the 
incoming power supply.
It's time to get the hot tub out.
Remove the spa control system's electrical and 
component cables (pump, blower, et cetera.).
Remove and disconnect the controller from the topside.
Silicone sealant or double-sided tape is used to 
connect most topsides. Fishing lines or dental 
floss may be used to access the tub's shell and 
topside.
Remove the heater's piping.
Removing the system's controls
An evaluation of pumps and components should 
be made. Decide whether or not they can be 
reused or if you'll need to buy new ones.
To conclude- 
To get expert advice, you may contact 
Hot tub Parts (Factory Direct) by calling 
them or visiting website to explore more. 
For more information about 
Spa Control System visit Hot tub parts FD.
Contact us:
Address: 4 Sycamore Way
Branford, CT 06405
Tel: 203-488-3615
Visit our website for more information: 
https://www.hottubpartsfd.com/zencart/i
ndex.php
Thank you…