6 Important Points to Look for Before Choosing a Spinning Can
                     
Introduction
● Choosing the right Spinning Can is crucial for producing high-quality Sliver 
in a Spinning Mill.
● A good Spinning Can not only ensures a quality product but also offers 
long-lasting durability, making it economically viable.
● Here are 6 important points to consider when selecting a Spinning Can.
Premium Quality HDPE Sheet
● The Body Sheet is the most exposed part of the Spinning Can and is 
prone to wear and tear.
● It is recommended to use HDPE Sheets with Kicking Bend and Standard 
Thickness to ensure durability.
● The sheets should have Zero Scratch Damage, Zero Ovality, Zero 
Overlapping, and Seamless press at Joint for optimal performance.
● The sheets should be assembled systematically at the site.
● It is important to look for Anti-Static finish in the inner surface of the 
sheet.
Stainless Steel for Top Rim & Band 
● Stainless Steel is recommended for the top rim and binder to prevent 
rusting and rough edges, which can affect the quality of the product.
● Galvanized Bottom Rim and Plate should be used in all types of cans.
● Steel rivets should be used at 7-8 inch intervals to ensure there are no 
gaps between spares and the body sheet, preventing fiber 
accumulation.
● Embossed sheets should be used for Bottom Rims and Plates.
Castor Wheels and Stainless Steel Wires
● Look for Ball Bearing Type 360-Degree Swiveling Castors, directly fixed 
to the bottom plate using nut bolts
● It is important to ensure that there is no play in the movement of the 
castors and that there is a minimum gap between the castors and the 
floor.
● Use Non-Adjustable Stainless Steel wire with Plastic Coating in Tying 
Chord for binding the springs with the Bottom Plate.
● Ensure that there is an equidistance between three parallel chords.
● Avoid directly tying the chords with the top plate.
Springs
● Coated springs should be used for cans to prevent ununiformed 
movement and balance issues during operations.
● The Spring Thrust should be checked according to specifications to 
ensure proper functioning.
● When requesting springs from a spinning can supplier, it is important to 
provide the proper specification with the pretension value filled in the 
specification sheet.
The Top Plate
● Top Plate production should be done using a single die.
● Plastic sheets should be used for cans up to 24 inches, while 18G Steel 
Sheets should be used for cans up to 48 inches.
● Embossed sheets with radial lines, circular lines, and pyramid points 
should be used for better grip on the spring and uniform holding of sliver.
● The top edge of the can should have evenness with a maximum 
deviation of 4.5 mm.
● The can should have uniform circularity with a tolerance of 10 mm.
● The can should be upright with a maximum deviation of 10 mm.
● The cylinder and joints of the can should be impact resistant.
“Choosing the right Spinning Can is key to produce the 
best quality of Sliver in a Spinning Mill. Choose wisely!”
THANK YOU
THANK YOU!
WEBSITE : jumaccans.com
EMAIL: [email protected]
PHONE NO: +91 33 4016 6100
ADDRESS: 21, C.R. Avenue, Kolkata - 700072, India
Get Additional Info on 
6 Important Points to Look for Before Ch
oosing a Spinning Can