Netgear EX7700 Setup 
                                                            Netgear EX7700 Setup
The Netgear EX7700 Setup is a Wi-Fi range extender that works with your existing Wi-Fi network to 
expand its range. It works by receiving your router's Wifi signal and then distributing it to regions that 
are not currently served by your network. It also helps in the reduction of dead spots and offers a 
stronger, more dependable connection. Setup is simple and just takes a few steps.
To configure your Netgear EX7700 WiFi range extender, follow these steps:
● Connect the range extender to a power source and turn it on.
● Connect a device (such as a laptop or smartphone) to the WiFi network of the range 
extender.
● Enter "www.mywifiext.net" into the address bar of a web browser. This will access the web-
based configuration page for the range extender.
● Enter the default login information.
● Follow the on-screen instructions to complete the setup process.
Unable to access Netgear EX7700 Setup Page?
If you are unable to configure the Netgear Nighthawk Extender EX7700, follow the 
steps below:
●Turn on the mesh range extender EX7700.
●Check that the power led light on the AC2200 is solid white.
●Now you can use any wireless device, such as a phone, tablet, or laptop.
●And then select the WIFI network option. There, you'll find Netgear ext.
●Connect the Netgear Nighthawk X6 network with your device.
●Once connected, launch any current Internet browser.
●And then enter www.mywifiext.net into the URL bar.
●You have arrived at the Netgear EX7700 new extender configuration page.
Netgear nighthawk setup via wps setup |EX7700      
     
The Netgear EX7700 wps setup is the fastest way to install the extender.    
  These are some steps for Nighthawk WPS setup :
●The first step is to connect the EX7700 extender to the wireless router.
●Once the extender power light has turned on, press the wireless protected setup 
button.
●And then press the WPS button on your main router.
●On both of your devices, the WPS led will now begin to blink.
●When the Netgear Nighthawk X6 Extender EX7700's LED stops blinking.
●If you have three (Power, WPS, and Router),  are  solid white.
●It shows that the Netgear AC2200 setup using the WPS method was successful.
●Connect any wireless-enabled device to the extender network now.
●The AC2200 Nighthawk Tri-band X6 will also include a device-led light.