What Do You Do First When Renovating a Bathroom
                     Renovating a Bathroom What to Do First
Bathroom renovations  can be daunting  compared to  redoing other  rooms
because  of  the  tasks  and  skills  needed.  A  bathroom  renovation  involves
heating,  plumbing,  electrics,  and  choosing  the  best  sanitaryware  and
brassware.  Renovating  a  bathroom is  a  huge  priority  and  requires  much
attention because a beautifully designed bathroom helps you feel refreshed
or relaxed. Since bathrooms are one of the most commonly used spaces in
the  house,  having  robust  plumbing  fittings  is  imperative.  Consulting
plumbers in Sacramento can help you select the best fixtures for  your
bathroom.
Here Are the Steps for Renovating a Bathroom.
Demolition
Any renovation project must begin with the demolition of the bathroom. First,
turn off the water and electricity to the toilet, sink, shower, and bathtub. Also,
you must be careful not to damage the underlying plumbing or wall wiring
while removing the wall tile. Additionally, remove the toilet and sink gently
without damage and be careful to look for mold or mildew growth.
Electrical Work
Older  homes  require  new  wiring  to  renovate  the  bathroom.  Old  wiring
deteriorates with time, and the wall tears cause the covers to break. You will
need to connect extra wires and plug-ins for electronic devices to upgrade
the  lighting  system  or  lights  in  the  shower  or  sink  area.  A  licensed
professional  with  experience  in  electrical  work  will  guide  you  about  the
electrical system and complete this task. The electrical panel may need to be
updated in some homes and bathrooms due to increased outlets and wiring
for  the lighting.  Before  the  drywall  is  installed,  all  the  wiring,  which  runs
between the frames, must be finished.
Related Article - Why is Plumbing Inspection Important?
Add Plumbing Fixtures
Install plumbing fixtures that comprise the bathtub, shower, sink, and toilet.
Check these fixtures before installation. You'll also need to cut through the
studs because the pipe could need to pass through the exterior walls. You
might need to install a waterproof membrane on the walls and floor if you
need  to  replace  the  tub  or  shower.  You  can  contact  the  best  plumbing
company in Sacramento, CA, for desired results.
Install Drywall
Before starting to paint, your new drywall needs to be installed. Then, fill any
gaps and seams with drywall compound and tape to create a flat surface. If
you're painting a bathroom, you should use a moisture-resistant finish to help
stop the growth of mold and mildew.
 To conceal seams and fill gaps, use drywall mud and tape.
 A cement board should be used for the shower/tub wall.
 To  protect  the  cement  board  from  water  damage,  cover  it  with
waterproofing film.
Conclusion
Bathroom redo gives your bathroom and home a refreshing look. Remodeling
your primary bathroom could increase your  home value and attract  high-
paying  customers.  Consulting  with  the  best  plumbing  company  in
Sacramento will help you install the appropriate fittings and fixtures. You can
have the best results with the best bathroom remodeling service plan and
approach.  Specific  requirements  and  expert  guidance  will  help  you
accomplish the bathroom remodeling process.
------- Article Source -------
https://www.emergencyplumbersca.com/renovating-a-bathroom-what-to-do-first/